Table of Contents
Advertisement
s.
you
. To
then
SYNC : In areas where the supply is at
60Hz(NTSC), 50Hz(PAL) frequency,
you can synchronize the output
phase of multiple cameras using
the power synchronization function
( L i n e - L o c k ) w i t h o u t u s i n g a
synchronization signal generator.
-
INT : Internal Synchronization Type
-
L/L : Power Synchronization Type, Line-lock
Set up the mode using the Function Setup switch.
You can select a desired phase from 0 to 359 when select 'phase'.
When using AC power at 60Hz(NTSC), 50Hz(PAL) frequency, you can use the L/L type
synchronization.
When the power is DC 12V, the SYNC menu is fi xed to the 'INT' mode.
MOTION DET :
Allows effective monitoring by displaying
"MOTION DET" message on the screen
whenever a motion is detected, for all 8
monitored split screens.
When the SPECIAL menu
screen is displayed, press
the Function Setup switch so
that the arrow indicates'MOTION
DET'.
Set up the mode using the Function Setup switch.
-
SENSITIVITY : You can select up to 8 MD areas. When SENSITIVITY
number is high, motion detection sensitivity is increased to
recognize even small movement.
-
AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
-
SEL POS : Determines which of the 4 vertices of each MD area is to be used.
-
XPOS : Determines the coordinate of the horizontal axis for SEL POS.
-
YPOS : Determines the coordinate of the vertical axis for SEL POS.
-
FILL
SET : Fills in a selected MD area. The color of fi lling is sequentially selected
as brown, orange, blue, cyan, green, yellow, magenta and red.
-
RETURN : Select this to save the MOTION DET menu settings and return
to the SPECIAL menu.
SYNC
PHASE
Press SET to Return
MOTION DET
1.SENSITIVITY
AREA1
2.AREA MODE
3.SEL POS
L-TOP
4.XPOS
5.YPOS
6.FILL
SET
7.RETURN
English_31
0
ON
3
5
Advertisement
Table of Contents
