Table of Contents
Advertisement
Chapter 2
Camera Installation
Secure the IP camera to the conduit base with two included screws.
Step 5
Feed a shielded twisted pair (STP) Category 5 or higher network cable through the conduit base and
Step 6
connect to the LAN port on the back of the camera. Connect the other end of the network cable to a
10/100/BaseT router or switch.
If your network provides PoE, the IP camera powers on.
(Optional) Feed the following cables through the conduit base and connect to the GPIO terminal block
Step 7
on the IP camera:
External power cable to the GPIO terminal block if PoE is not available.
•
(Optional) I/O cables for external input or out put devices, such as sensors or alarms, to the GPIO
•
terminal block
The pin locations and descriptions are as follows:
(Optional) Use a mini cable with BNC connector to temporarily attach an NTSC or PAL compliant
Step 8
analog video display device to the analog video out port on the IP camera.
OL-28120-02
1
2
3
4
5
6
7
8
Pin
Description
1
12 VDC-
2
12 VDC+
3
24 VAC
4
24 VAC
5
DI-
6
DI+
7
DO-
8
DO+
Cisco Video Surveillance 6020 IP Camera Installation Guide
IP Camera Installation
2-11
Advertisement
Table of Contents
