Mounting The Ip Camera With A Vandal Resistant Enclosure - Cisco 6020 Installation Manual

IP Camera Installation
What to do next
Complete the following procedures:
•
•

Mounting the IP camera with a Vandal Resistant Enclosure

To mount the 6020 IP camera using a vandal resistant (VR) enclosure, complete the following steps:
Procedure
Attach the included alignment sticker to the ceiling or wall.
Step 1
Using the circle marks on the sticker, drill at least 2 pilot holes symmetrically on each side into the
Step 2
ceiling or wall. Then hammer the included plastic anchors into the holes.
Do one of the following:
Step 3
•
•
Secure the conduit base to the ceiling or wall with two included screws.
Step 4
Cisco Video Surveillance 6020 IP Camera Installation Guide
2-10
After you install the IP camera, follow the instructions in the
Camera" section on page 3-1
After completing the initial setup, use the IP camera user interface to adjust the focal length and
zoom factor. For more information, see the
page 4-3.
To feed cables through a ceiling or wall, cut out a section of the ceiling or wall that corresponds to
the triangular cutout on the alignment sticker.
To feed cables through the side of the conduit base, use a screwdriver to remove the cutout on the
side of the conduit base.
to access the IP camera through your network.
"Adjusting the IP Camera Focus and Zoom" section on
Chapter 2 Camera Installation
"Performing the Initial Setup of the IP
OL-28120-02