Ip Camera Installation; Mounting The Ip Camera Directly To A Surface - Cisco 6020 Installation Manual

Video surveillance ip camera

Hide thumbs Also See for 6020:

Table of Contents

IP Camera Installation

Install the 6020 IP camera using one of the following procedures:

•

To directly mount the 6020 IP camera to a surface, complete the following steps:

Procedure

Attach the included alignment sticker to the ceiling or wall.

Step 1

Using the circle marks on the sticker, drill 2 pilot holes symmetrically on each side into the ceiling or

Step 2

wall. Then hammer the included wall anchors into the holes.

Secure the IP camera to the ceiling or wall with the included screws.

Step 3

Connect an STP (shielded twisted pair) Category 5 or higher network cable to the LAN port on the back

Step 4

of the camera. Connect the other end of the network cable to a 10/100/BaseT router or switch.

If your network provides PoE, the IP camera powers on.

(Optional) Connect the following cables to the GPIO terminal block:

Step 5

•

Cisco Video Surveillance 6020 IP Camera Installation Guide

2-4

Mounting the IP Camera Directly to a Surface, page 2-4

Mounting the IP Camera Flush with a Surface, page 2-7

Mounting the IP camera with a Vandal Resistant Enclosure, page 2-10

External power cable if Power over Ethernet (PoE) is not available.

I/O cables for external input or out put devices, such as sensors or alarms.

Chapter 2

Camera Installation

OL-28120-02

Table of Contents