Setting Up The Basic Menu Using Network Operations; Basic Settings Menu Outline - Sanyo DSR-3716PA Manual For Remote Operation

Setting up the Basic Menu Using Network Operations

The DVR operating condition is usually set through the
DVR. However, the following basic operation menu allows
you to set the DVR using the computer.

Basic Settings Menu Outline

b Initial setting
A CLOCK SET (Refer to P24)
Setting the DVR's clock
B SUMMER TIME SET/EXT. CLOCK SET (Refer to
P24)
To set the automatic summer time change and the
automatic setting of the connected DVR clock.
C HOLIDAY SET (Refer to P24)
To set dates that will be considered as holidays.
b Recording settings
A RECORDING AREA SET (Refer to P25)
To display the proportion of each recording area and
set the recording resume operation when recording
was stopped due to the recording exceeding the area
capacity.
B RECORDING CONDITIONS SET (Refer to P26)
To choose overwriting and other hard disk related
condition settings.
C NORMAL REC MODE SET (Refer to P27)
Normal and timer-controlled recording condition
settings.
D PROGRAM REC SET (Refer to P28)
To program the individual or the combined recording
rate of the recording cameras
E TIMER SET (Refer to P28)
Timer-controlled recording condition settings.
F ALARM REC MODE SET (Refer to P30)
Alarm recording and pre-alarm recording condition
settings
The setting menus outside the ones above are outside the scope of network operations. Therefore, use the
DVR to set any other settings.
b General settings
A DISPLAY SET (Refer to P32)
To set the information display for the connected
monitors.
B BUZZER SET (Refer to P32)
Warning buzzer settings
C HDD SET (Refer to P33)
To set HDD information display and specify the
playback disk when 2 HDD units are connected.
D NETWORK SET (Refer to P34)
To set the network connection conditions and the
connection password.
E RS-485 SET (Refer to P34)
DVR interface information display when operating the
system controller
b Screen settings and DVR information
A MASK SET (Refer to P35)
Mask settings for specific channels
B POWER LOSS/USED TIME (Refer to P35)
Power loss history, operating time, firmware version,
etc. information display
C INITIALIZATION LOG (Refer to P35)
Hard disk initialization history information display
22
(User level: ID3)
English