Rolling Code Programming - Ford Fusion Hybrid Owner's Manual

Driver Controls
do not press any button until the module times out after approximately
2.5 seconds and resets to normal mode. When time-out occurs, all three
LEDs will flash rapidly for a few seconds then turn off. Any settings
should remain as previously set.

Rolling code programming

Note: Programming the rolling code garage door opener involves
time-sensitive actions. Read the entire procedure prior to beginning so
you will know which actions are time-sensitive. If you do not follow the
time-sensitive actions, the device will time out and you will have to
repeat the procedure.
Note: Do not program the Car2U system with the vehicle in the garage.
Make sure that your key is on and engine off while programming the
transmitter.
1. Firmly press the two outer
Car2U system buttons for
1–2 seconds, then release.
2. Go to the garage to locate the
garage door opener motor and its
"learn" button. You may need a
ladder to reach the unit and you
may need to remove the unit's cover
or light lens to locate the "learn"
button. Press the "learn" button,
after which you will have
10–30 seconds to return to your
vehicle and complete the following
steps. If you cannot locate the
"learn" button, refer to the Owner's Guide of your garage door opener or
call the toll-free Car2U system help line at 1-866-57Car2U
(1-866-572-2728).
105
2012 Fusion Hybrid (hfv)
Owners Guide, 1st Printing
USA (fus)