Distinctive Ring Detection; Auto Reduction Sending Setting; Rotation Sending Setting; Disable Of Fax Number Direct Entry - Oce im4512 Facsimile Operation Manual

ECM
(This setting is only effective if the other machine
is a G3 machine that supports ECM)
Line conditions can
transmitted fax image.
Correction Mode) is turned on, pages that are
distorted are automatically re-transmitted. This
setting is initially turned on. If turned off, distorted
images will be transmitted without being corrected.
NOTE
If the other machine supports Super G3, ECM will
function regardless of the setting.

Distinctive ring detection

If multiple telephone numbers have been assigned
to your telephone line, the number called can be
identified by its ringing pattern. By using one
number for voice calls and another number for
faxes, you can tell which type of call you are
receiving by the ringing pattern. You can set your
machine to automatically receive faxes when your
fax number is called by setting the pattern that
corresponds to your fax number. Six selections are
available. Normally OFF is selected.

Disable of fax number direct entry

When the fax function is enabled, this program is
used to prohibit dialing of a destination fax number
by direct entry with the numeric keys. To prohibit
dialing by direct entry with the numeric keys, touch
the checkbox to select it. When this is done, faxes
can only be sent to destinations that have been
stored, and thus this program can be used to
restrict fax destinations and prevent accidental
transmission to an incorrect number. The following
operations are also prohibited:
G Storing one-touch dial numbers
G Direct entry of fax numbers when storing a group
G Direct entry of fax numbers of relay destinations
in a relay broadcast memory box
sometimes distort a
When ECM (Error
KEY OPERATOR PROGRAMS
I I I I Fax send settings
The fax transmission settings allow you to adjust
certain parameters for sending faxes to better suit
your needs.
The fax send settings are as follows:
G Auto reduction sending setting
G Rotation sending setting
G Printing page number at receiver
G Call timer at memory sending
G Date/own number print position setting
G Quick on line sending
G Recall in case of line busy
G Recall in case of communication error

Auto reduction sending setting

This setting lets you select whether to have a
transmitted document reduced to match the size of
the other machine's printing paper. Auto reduction
is normally turned on. If the setting is turned off,
documents are sent in their original size. Because
the size is not adjusted to match the size of the
printing paper, part of the received document may
be cut off.

Rotation sending setting

When transmitting a document, this setting allows
you to rotate a vertically oriented 8-1/2"x11" (A4)
document to a horizontal orientation (8-1/2"x11"R
(A4R)), or rotate a 5-1/2"x8-1/2R" (A5R) document
to 5-1/2"x8-1/2" (A5). The setting is normally
turned on, and
counterclockwise. (8-1/2"x11"R (A4R) documents
are not rotated.)
KEY OPERATOR PROGRAMS
ROTATION SENDING SETTING
ORIGINAL
SET
1
8 X11
2
1 1
5 X8 R
2
2
Rotation settings can be separately established for
different document sizes. To turn off a rotation
setting, touch the checkbox of the appropriate
setting to remove the checkmark.

Printing page number at receiver

This setting lets you select whether page numbers
are printed at the top of fax pages by the receiving
machine. The normal setting is to have page
numbers printed.
documents are rotated
OK
SENDING
DIRECTION
1
8 X11R
2
1 1
5 X8 B5
2
2
8-7
8