Operating The Surround Functions - Denon ADV-M71 Operating Instructions Manual

ENGLISH
(9) Slow Playback (for DVDs and video CDs only)
1 In the still mode, press one of the
remote control unit.
6
7
• When pressed again, the slow play speed increases.
(Four step) (Three step on video CDs)
• Press the PLAY button to resume normal playback.

12 OPERATING THE SURROUND FUNCTIONS

B
DVD SURROUND RECEIVER ADV-M71
ON / STANDBY
(1) Input mode setting
1 Press the FUNCTION button to select the input function to be
played.
FUNCTION
Main unit
• The function switches as shown below.
• Factory default (LINE 1) = MD, (LINE 2) = TAPE
DVD
2 When DVD, D.AUX was selected as the input function, press
the remote control unit's INPUT MODE button to select the
input mode.
AUTO
• "ANALOG" cannot be selected when DVD or D.AUX was
selected as the input function.
• "ANALOG" can be selected when "LINE-2" is set to
"D.AUX" at "FUNCTION ASSIGNMENT" under "SYSTEM
SETUP" in the detailed settings.
44
6 / 7 buttons on the
: Reverse direction
: Forward direction
SURROUND / SELECT
PUSH - PARAM.
- +
MENU / SET
TONE / SDB VOLUME
FUNCTION
PHONES
1 3 5
FUNCTION
Remote control unit
TUNER (LINE1) (LINE2) D.AUX
INPUT MODE
Remote control unit
PCM DTS ANALOG
NOTE:
• Reverse slow play is not possible on video CDs.
BAND
Input mode selection function
• The input mode can be selected when the input function is
set to DVD, D.AUX.
• Different input modes can be selected for each input
function. The selected input mode is stored in the memory
for the individual input functions.
• When the input function is set to something other than the
above, "ANALOG ONLY" is displayed and the input mode
cannot be selected.
q AUTO (auto mode)
In this mode, the type of signal being input to the digital
and analog input terminals is detected and the program in
the set's surround decoder is switched automatically to
play the signals for the selected input function.
The presence or absence of digital signals is detected, the
signals input to the digital input are identified and decoding
and playback are performed automatically in DTS, Dolby
Digital or PCM (2 channel stereo) format.
If no digital signal (LINE1) = MD is being input, the analog
input jacks are selected.
Use this mode to play Dolby Digital signals.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM
signals are being input.
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS
signals are being input.
r ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are played.
( This cannot be selected in the DVD mode.)
The input mode automatically switches to "AUTO" if you
switch the input function to DVD from anything other than
DVD.
6 7
Remote control unit
-
4 5 6
TUNER
5CH STEREO AUTO DECODE
+
7 8 9
CH
1
DIRECT STEREO VIRTUAL
-
+ 10
0
CALL
/10
TEST TONE INPUT MODE SURROUND FUNCTION
3
2
TUNER TV / VCR
A / V DVD IN/SURR.
SYSTEM MD IN/SURR.
CDR TAPE
1 2 +
DVD
5
8 9
-
6 7
STATUS
3 MUTING
SETUP TONE /SDB
ENTER
SURROUND