Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bosch NPD-6001A
Summary of Contents for Bosch NPD-6001A
- Page 1 High PoE Midspans NPD-6001A │ NPD-9501A Installation Manual...
-
Page 3: Table Of Contents
About this Manual Legal Information Safety Precautions Important Safety Instructions Customer Support and Service Unpacking Parts List Additional Parts Required Tools Required Additional Parts Recommended But Not Required System overview Installation Connection Troubleshooting Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912... -
Page 4: Safety
Because of the ongoing development of products, the content of the manual may change without notice. Bosch Security Systems accepts no liability for damage resulting directly or indirectly from faults, incompleteness, or discrepancies between the manual and the product described. -
Page 5: Important Safety Instructions
(1) 230 V power cord, please note the following as it applies to your region: – The power cord must have regulatory agency approval for the specific country in which it is being used (i.e., UL, CSA, VDE, etc.). Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912... - Page 6 The Data In and Data & Power Out interfaces are qualified as SELV (Safety Extra-Low Voltage) circuits according to IEC 60950-1. These interfaces can only be connected to SELV interfaces on other equipment. Recycling and Disposal: 2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems...
- Page 7 High PoE Midspans Safety | en Your Bosch product was developed and manufactured with high- quality material and components that can be recycled and reused. This symbol means that electronic and electrical appliances, which have reached the end of their working life, must be collected and disposed of separately from household waste material.
-
Page 8: Customer Support And Service
| Safety High PoE Midspans Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Service Centers Telephone: 800-366-2283 or 585-340-4162 Fax: 800-366-1329 Email: cctv.repair@us.bosch.com... - Page 9 High PoE Midspans Safety | en More Information For more information please contact the nearest Bosch Security Systems location or visit www.boschsecurity.com Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
-
Page 10: Unpacking
High PoE Midspan 95W 120 V power cord 230 V power cord Installation Manual (this document) Additional Parts Required The following table lists additional parts (not supplied by Bosch) required to install the midspan: 2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems... -
Page 11: Tools Required
“Data In” port. Tools Required Screwdriver Additional Parts Recommended But Not Required The following table lists additional parts (not supplied by Bosch) recommended to install the midspan: Quantity Part Surge suppressor Splitter Universal Power Supply (UPS) Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912... -
Page 12: System Overview
| System overview High PoE Midspans System overview Bosch sells two (2) models of midspans (a 60 W model and a 95 W model) that enable remote power over an IP network connection for specific Bosch IP cameras. Rated for indoor installation only, the midspans can be installed indoors and wired to a camera installed outdoors. - Page 13 High PoE Midspans System overview | en Note: The total length of Cat5e/Cat6 cable must be less than 100 m (328 ft) between the camera and the head-end system. Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
-
Page 14: Installation
ANSI/NFPA 70 (the National Electrical Code (NEC)), ® Canadian Electrical Code, Part I (also called CE Code or CSA C22.1), and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any damages or losses caused by incorrect or improper installation. Warning! - Page 15 Stack One Unit on Top or on the Side of Another Unit Slide the rail on the right side (when facing the ports) of one unit to the left side (when facing the ports) of a second unit. Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
-
Page 16: Connection
Connect the Data In (input) port to the remote Ethernet network switch. Connect the Data & Power Out (output) port to the Ethernet port on the AutoDome camera. Note: Do NOT use cross-over cable! 2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems... - Page 17 High PoE Midspans Connection | en Figure 5.1: Midspan_DataIn_DataOut_Connections 1 AC input connectivity indicator 2 Port connectivity indicator 3 CAT5 cable 4 Connection to camera 5 Connection to Ethernet switch Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
-
Page 18: Troubleshooting
- data at 1 Hz rate or/and spare, (PD or cable fault) – Blinking yellow – Internal fault condition or green at 4 Hz rate 2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems... - Page 19 (OVL) event occurred. After AC voltage is supplied, the green LED will blink, and then the yellow LED will blink, each for one second. Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
- Page 20 If the camera works, then there is probably a faulty port or RJ45 connection on the midspan. 7. Verify that there is not a short over any of the twisted pair cables or over the RJ45 connectors. 2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems...
- Page 21 100 meters from the Ethernet source to the camera. 5. Try to reconnect the camera to a different midspan. If the camera works, then there is probably a faulty port or RJ45 connection on the midspan. Bosch Security Systems 2015.06 | 3.1 | F.01U.304.912...
- Page 24 Bosch Security Systems, Inc. Bosch Sicherheitssysteme GmbH 850 Greenfield Road Robert-Bosch-Ring 5 Lancaster, PA, 17601 85630 Grasbrunn Germany www.boschsecurity.com © Bosch Security Systems, Inc., 2015...
Need help?
Do you have a question about the NPD-6001A and is the answer not in the manual?
Questions and answers