Network Submenu; Default Submenu - Bosch DINION 5000 IP Installation Manual

36 en | Configuration
4.2.3

Network submenu

To operate the DINION capture 5000 IP in your network, a
network-valid IP address must be assigned. The factory default
IP address is 192.168.0.1.
Item
IP Address
Subnet Mask
Gateway
DHCP
EXIT
The new IP address, subnet mask, and gateway address are set
when leaving the menu. The camera reboots internally and the
new values are set after a few seconds.
4.2.4

Default submenu

Item
Restore All?
| 1.0 | 2012.01
Selection
Selection
No, Yes
Installation Manual
Description
Enter an IP address for the camera.
Use LEFT/RIGHT to change position in
the address, use UP/DOWN to select
the digit. Use SELECT to exit the
address edit screen.
Enter the Subnet mask (default
255.255.255.0).
Enter a Gateway address.
If the network has a DHCP server for
dynamic IP address allocation, set this
parameter to On to activate the
automatic acceptance of DHCP-
assigned IP addresses.
Returns to Install menu.
Description
Restores all settings of the six modes
to their default (factory) values. Select
YES then press the Menu/Select
button to restore all values.
When completed the message
RESTORED! is shown.
DINION capture 5000 IP
Bosch Security Systems, Inc.