Connecting To A Hardware Decoder; Alarm Connection - Bosch DINION 5000 IP Installation Manual

DINION capture 5000 IP
5.4

Connecting to a hardware decoder

A compatible H.264 hardware decoder with a monitor can be
connected to the camera using an Ethernet network
connection. Cameras are designed to automatically connect
with other BVIP devices with the correct configuration. The
units only need to be part of the same closed network. In this
way it is possible to cover large distances with little installation
or cabling effort.
5.4.1

Alarm connection

With the appropriate configuration, a connection between
camera and decoder is established automatically when an alarm
is triggered. After a short time, the live video image from the
transmitter is shown on the connected monitor. In this case, no
computer is needed to establish the connection.
Note:
Make sure the devices are configured for the network
environment and that the correct IP address for the remote
location is set on the Alarm connections configuration page.
Bosch Security Systems, Inc. Installation Manual
Browser connection | en
| 1.0 | 2012.01
39