Pro-Form 535 User Manual page 8

CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing at
the lower right) whilst using the treadmill.
When the key is removed from the console,
the walking belt will stop.
• Adjust the speed in small increments.
• The pulse sensor is not a medical device.
Various factors may affect the accuracy of
heart rate readings. The pulse sensor is in-
tended only as an exercise aid in determin-
ing heart rate trends in general.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
BATTERY INSTALLATION
The console requires two 1,5 V batteries (included).
Alkaline batteries are recommended. Open the battery
cover as shown in the drawing at the upper right. Insert
two batteries into the battery compartment, making
8
ON/RESET Button
Note: If there is a thin sheet of clear plastic on the face
of the console, remove it before operating the console.
Before operating the
Battery
Cover
Batteries
sure that the negative (–) ends of the batteries are
touching the springs in the battery compartment. Close
the battery cover, push up on the battery cover tab,
and then push the tab forward as shown in the inset
drawing. Be sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot
rails of the treadmill. Find
the clip attached to the key,
and slide the clip onto the
waistband of your clothing.
Follow the steps on page 9 to operate the console.
Battery
Cover Tab
Clip