Trouble-Shooting - Pro-Form 535 User Manual

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, please call our Customer Service
Department at 0345-089009 (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. If an extension cord is needed, use only a 3-conductor, 14-gauge (1mm
meters (five feet). Important: The treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit
breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our Customer Service Department.
3. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
a. Check the batteries in the console. See BATTERY INSTALLATION on page 8. Most problems are the result
of drained batteries.
b. Remove the key from the console and UNPLUG THE POWER
CORD. Remove the screws from the hood. Carefully remove the
hood. Locate the Reed Switch (44) and the Magnet (45) on the
left side of the Pulley (50). Turn the Pulley until the Magnet is
aligned with the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 3 mm. If necessary,
loosen the Screw (33), move the Reed Switch slightly, and then
retighten the Screw. Re-attach the hood, and run the treadmill for
a few minutes to check for a correct speed reading.
12
2 ) cord that is no longer than 1.5
c
Reset
Tripped
Tripped
b
3 mm
44
45
33
Top
View
Reset
50