Advertisement
Checking the Hole-Punching Positions for FN-107
NOTE
• For details on the installing FN-107, refer to its Setup Instructions.
• To adjust FN-107, follow the instructions below.
• To exit the External Panel Controller, refer to step 14 on page 24.
C4004P565CA
C4004P597CA
C4004P588CA
4004-7715-01
1. Unplug the power cord, and then turn off the
printer.
2. Load A4-size (or Letter-size) paper (in land-
scape orientation) into Tray 1.
3. Check that the External Panel Controller
appears in the computer screen, and then
display the Tech. Rep. Mode screen. (For
details about displaying the Tech. Rep. Mode
screen, refer to the Service Manual.)
4. Click [Machine Adjust].
5. Click [Staple/Hole-Punch].
CF2001P
C4683P005CA
– 35 –
6. Click [Hole-Punch].
7. Click the Start key in the External Panel
Controller.
8. Fold the paper that is fed out in half, and
check that the punched holes are aligned.
Standard position: ±2mm
NOTE
If the punched holes are not at their stan-
dard positions, adjust the hole-punching
position.
4643U031AA
NEXT
NEXT
Advertisement
