Common Autodome User Commands (Unlocked); Setting Autopan Mode; Setting Preset Shots - Bosch VG4-200 User Manual

30 en | Common AutoDome User Commands (unlocked)
3

Common AutoDome User Commands (unlocked)

This chapter details the commonly used Bosch keyboard setup commands. See
Section 6 Keyboard Commands by Number, Page 44, for a complete list of commands.
3.1

Setting AutoPan Mode

AutoPan mode pans the AutoDome camera 360º or pans between user defined limits (when
programmed). The AutoDome camera continues to pan until stopped by moving the joystick.
To pan 360º:
1.
2.
To set left and right pan limits:
1.
2.
To start AutoPan between limits:
1.
2.
3.2

Setting Preset Shots

Preset shots are saved camera positions. Shots are saved as scenes, therefore, the terms
SHOT and SCENE are used interchangeably.
To set a Shot:
1.
2.
3.
To view a Shot:

To store or clear a Shot:
1.
2.
F.01U.133.268 | 6.0 | 2010.03
Press ON-1-ENTER.
Move the joystick to stop the pan.
Move the camera to the starting position and press SET-101-ENTER to set the left limit.
Move the camera to the end position and press SET-102-ENTER to set the right limit.
Press ON-2-ENTER.
Move the joystick to stop the pan.
Move the camera to the position you want to save.
Press SHOT-#-ENTER where # can be a number from 1 to 99 that identifies the camera
position of the scene. (shots 1-64 for a 200 Series AutoDome.)
To specify a title for the shot, see the procedure below.
Press SHOT-#-ENTER where # is the number of the scene position you want to view.
Press SET-100-ENTER to access the Store/Clear Scene Menu.
Follow the on-screen instructions.
User's Manual
VG4 Modular Camera System
Bosch Security Systems, Inc.