Advanced Mode: Password - Bosch VG4-200 User Manual

VG4 Modular Camera System
You can use the second line for entering additional characters; these can be selected from a
table.
1.
2.
3.
4.
5.
Initiator extension
You can attach your own text to the initiator name of the IP AutoDome to make the unit easier
to identify in large iSCSI systems. This text is added to the initiator name, separated from it by
a full stop. You can see the initiator name in the system overview (see Section 10.59 Advanced
Mode: System Overview, page 116).
10.9

Advanced Mode: Password

An IP AutoDome is generally protected by a password to prevent unauthorized access to the
unit. You can use different authorization levels to limit access.
NOTICE!
Proper password protection is only guaranteed when all higher authorization levels are also
protected with a password. If a live password is assigned, for example, a service and a user
password must also be set. When assigning passwords, you should therefore always start
from the highest authorization level, service, and use different passwords.
Password
The IP AutoDome operates with three authorization levels: service, user and live.
The highest authorization level is service. After entering the correct password, you can access
all the functions of the IP AutoDome and change all configuration settings.
With the user authorization level, you can operate the unit and also control cameras, for
example, but you cannot change the configuration.
The lowest authorization level is live. It can only be used to view the live video image and
switch between the different live image displays.
You can define and change a password for each authorization level if you are logged in as
service or if the unit is not password protected.
Enter the password for the appropriate authorization level here.
Confirm password
In each case, enter the new password a second time to eliminate typing mistakes.
Bosch Security Systems, Inc.
Click the icon next to the second line. A new window with the character map is opened.
Click the required character. The character is inserted into the Result field.
In the character map, click the << and >> icons to move between the different pages of
the table, or select a page from the list field.
Click the < icon to the right of the Result field to delete the last character, or click the X
icon to delete all characters.
Now click the OK button to apply the selected characters to the second line of the
Camera 1 parameters. The window will close.
User's Manual
Configuring the IP AutoDome | en
F.01U.133.268 | 6.0 | 2010.03
73