Bosch VG4-200 User Manual page 60

60 en | Using the IP AutoDome
Using the IP AutoDome Web Server
The IP AutoDome incorporates a network video server in the IP module.
To configure the camera using the IP AutoDome Web server, do the following:
1.
2.
3.
4.
5.
6.
7.
NOTICE!
Click the Help on this page? link if you need more information.
8.
9.
10. Type the original IP address followed by /reset (for example, http://192.168.0.1/reset) in
11. Disconnect the IP AutoDome Ethernet cable from the dedicated network switch and
F.01U.133.268 | 6.0 | 2010.03
Set the IP address on the PC to 192.168.0.10 to ensure that the PC and the IP
AutoDome are on the same Subnet.
Launch Microsoft Internet Explorer and navigate to the following URL: http://192.168.0.1
The Web browser opens the LivePage for the IP AutoDome; a security warning message is
displayed.
Check the Always Trust box, then click YES.
Click the Settings link, located at the top of the LivePage.
Click the Service Settings link, located in the left pane of the Settings window.
Click the Network link to open the Network Settings page.
Figure 8.2 Network Settings Page
Configure the settings on this page based on the addresses provided by your local
network administrator.
Click the Set button to save the settings.
Launch another instance of Microsoft Internet Explorer.
the address bar and click Go to restart the IP AutoDome. Once you restart the IP
AutoDome, use the new IP Address to access the LivePage.
reconnect the Ethernet cable to the local area network (LAN).
User's Manual
VG4 Modular Camera System
Bosch Security Systems, Inc.