Common Autodome User Commands (Unlocked); Setting Autopan Mode; Setting Preset Shots; Configuring Preposition Tours - Bosch series VG4-300 User Manual

AutoDome Modular Camera System
3

Common AutoDome User Commands (unlocked)

This chapter details the commonly used BOSCH keyboard setup commands. See
Section 6: Keyboard Commands by Number on page 33 for a complete list of commands.
3.1

Setting AutoPan Mode

AutoPan mode pans a PTZ camera 360º or pans between user defined limits (when pro-
grammed). The PTZ camera continues to pan until stopped by moving the joystick.
To pan 360º:
1.
2.
To set left and right pan limits:
1.
2.
To start Auto-pan between limits:
1.
2.
3.2

Setting Preset Shots

Preset shots are saved camera positions. Shots are saved as scenes, therefore, the terms
SHOT and SCENE are used interchangeably.
To set a Shot:
1.
2.
To view a Shot:
To store or clear a Shot:
1.
2.
3.3

Configuring Preposition Tours

A Preposition Tour automatically moves the camera through a series of preset or saved shots.
There are two (2) types of tours: a standard serial tour and a customized tour.
Tour 1 is a standard tour that moves the camera through a series of shots in the sequence
they were set. Tour 2 is a custom tour that allows you to change the sequence of shots in the
tour by inserting and deleting scenes.
To start standard Tour 1:
1.
2.
To stop a Tour:
Bosch Security Systems, Inc.
Press ON-1-ENTER.
Move the joystick to stop the pan.
Move the camera to the starting position and press SET-101-ENTER to set the left limit.
Move the camera to the end position and press SET-102-ENTER to set right limit.
Press ON-2-ENTER.
Move the joystick to stop the pan.
Move the camera to the position you want to save.
Press SHOT-#-ENTER where # can be a number from 1 to 99 that identifies the camera
position of the scene. (shots 1-64 for a 200 Series AutoDome.)
Press SHOT-#-ENTER where # is the number of the scene position you want to view.
Press SET-100-ENTER to access the Store/Clear Scene Menu.
Follow the on-screen instructions.
Set a series of preset shots in the order that you want the AutoDome to cycle through.
Press ON-8-ENTER to start the tour. The tour then cycles through the series of shots until
it is stopped.
Press OFF-8-ENTER or move the joystick to stop either type of tour.
VG4-200, VG4-300, VG4-500i Series User's Manual
Common AutoDome User Commands (unlocked) | en 23
F01U064036 | 1.0 | 2007.01