Wall Mounting; Charging The Battery - Black & Decker CHV9610 Instruction Manual

Assembly

Wall Mounting

The product can be wall mounted, if desired,
using the wall mount bracket, screws and
anchors supplied. To wall mount the vac, refer
to figures B, C, D and E.
• figure B - Mark the location of the screw
holes (within reach of an electrical outlet
for chargeing the vac while it is on the wall
bracket).
• figure C - Insert the charger cord into the
curved slot in the wall mount bracket leaving
approximately 8-9 inches (203mm - 227mm)
excess as shown.
• figure D - Hang the vac on the wall by placing the opening on the
base of the vac over the hooks in the wall mount bracket as shown in
figure D.
• figure E - Insert the jack plug into the
charging socket.

Charging the battery

From new, the rechargeable cells of the product need a minimum charge time of 24
hours to ensure full power.
We suggest you fully discharge the product when it is used for the first time as this will
help the cells recharge faster.
• The switch must be in the off ("O") position, the
product will not charge if it is in any other position.
• figure f - Plug the jack plug of the charger into
the charging socket of the tool. Plug the charger
into any standard 120 Volt 60 Hz electrical outlet.
The charging indicator will be lit.
While charging, the charger may get warm, this
is perfectly normal and safe. It can remain on
charge indefinitely without damage or danger. It
is not possible to "overcharge" the battery cells
with the charger provided.
• The charging indicator will be lit as long as the
appliance is connected to the plugged-in charger.
WARNING:
battery at ambient temperatures below 39°F
(4°C) or above 104°F (40°C).
Do not charge the
4
B
E
F
C
D