Table of Contents
Advertisement
Integrated IR Bullet Camera
14.
Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in a
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
1.3
Important Safety Instructions
CAUTION!
1.
A regulated DC12V 1A power supply is recommended for
use with this camera for the best picture and the most
stable operation. An unregulated power supply can cause
damage to the camera. When unregulated power supply is
applied, product warranty will be out of subject.
2.
It is recommended that the camera is used with a monitor
that has a CCTV quality 75 Ohm video impedance level. If
your monitor is switched to high impedance then please
adjust accordingly.
3.
Do not attempt to disassemble the camera to gain access
to the internal compounds. Refer servicing to your dealer.
4.
Never face the camera towards the sun or any bright or
reflective light, which may cause smear on the picture and
possible damage to the CCD.
5.
Do not remove the serial sticker for the warranty service.
All-pole power switch - Incorporate an all-pole power switch,
with a contact separation of at least 3 mm in each pole, into the
electrical installation of the building. If it is needed to open the
housing for servicing and/or other activities, use this all-pole
switch as the main disconnect device for switching off the
voltage to the unit.
Camera grounding - For mounting the camera in potentially
damp environments, ensure to ground the system using the
ground connection of the power supply connector (see section:
Connecting external power supply).
Bosch Security Systems, Inc.
Installation Manual
Safety | en
7
| 1.0 | 2011.01
Advertisement
Table of Contents
