WZ16 Integrated IR Bullet Camera Table of Contents | en Table of Contents Safety Safety Precautions Important Safety Instructions Important Notices FCC & ICES compliance CSA certification Warranty / Limitation of Liability Introduction Parts Included Installation and Connection Configuration Adjusting the Zoom...
| Safety WZ16 Integrated IR Bullet Camera Safety Safety Precautions DANGER! High risk: This symbol indicates an imminently hazardous situation such as “Dangerous Voltage” inside the product. If not avoided, this will result in an electrical shock, serious bodily injury, or death.
Page 5
WZ16 Integrated IR Bullet Camera Safety | en Do not put objects inside the camera. Make sure that no metal objects or flammable substances enter the camera. This may cause fire, short-circuits and other damages. 10. Be careful when handling the camera. To prevent damage, do not drop the camera or subject it to strong shock or vibration.
| Safety WZ16 Integrated IR Bullet Camera Important Notices Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount. The unit may fall, causing serious injury and/or serious damage to the unit. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer.
Page 7
Disposal - Your Bosch product was developed and manufactured with high-quality material and components that can be recycled and reused. This symbol means that electronic...
Page 8
Safety (power) ground is indicated by the symbol The system ground is only used to comply with safety standards or installation practices in certain countries. Bosch does not recommend connecting system ground to safety ground unless it is explicitly required. However, if the system ground and | 1.0 | 2011.02...
CCTV system. Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information. To minimize the risk of lost digital information, Bosch Security Systems recommends multiple, redundant recording systems, and a procedure to back up all analog and digital information.
Page 10
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; – Consult your Bosch Service Center, dealer, or an experienced radio/TV technician for further advice. Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made.
Page 11
WZ16 Integrated IR Bullet Camera Safety | en successivement hors et sous tension, tout en contrôlant la réception radio ou télévision. L'utilisateur peut parvenir à éliminer les interférences éventuelles en prenant une ou plusieurs des mesures suivantes: – Modifier l'orientation ou l'emplacement de l'antenne réceptrice;...
The Night Vision B&W & DSP Color CCD Camera has a three- year warranty. BOSCH Security Systems warrants that its products, at the time of shipment by BOSCH Security Systems, are free from defect in material or workmanship under normal use and service for the respective warranty periods specified in the applicable Price Schedule or as otherwise published.
Page 13
Product which is returned by Buyer during the applicable warranty period, or services for which timely notice of defect has been given by Buyer, and which are found by BOSCH Security Systems to be subject to adjustment under this warranty.
| Introduction WZ16 Integrated IR Bullet Camera Introduction The WZ16 Integrated IR Bullet Camera is a night vision DSP Color CCD camera that uses a 1/3 in. CCD solid-state imaging device that provides superior performance. The camera can be installed easily in most indoor and outdoor locations.
WZ16 Integrated IR Bullet Camera Installation and Connection | en Installation and Connection DANGER! RISK OF ELECTRIC SHOCK! DO NOT OPEN THE UNIT! WARNING! To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the following installation instructions.
Page 16
| Installation and Connection WZ16 Integrated IR Bullet Camera Figure 3.1 Camera mounted on ceiling Figure 3.2 Camera mounted (from bottom) on Wall | 1.0 | 2011.02 Installation Manual Bosch Security Systems, Inc.
Page 17
Installation and Connection | en Figure 3.3 Camera mounted (from top) on Wall Connect the camera to the video monitor. Bosch recommends using a monitor with a CCTV quality 75Ω video impedance level. If your monitor is switched to high impedance, please adjust the monitor accordingly.
| Configuration WZ16 Integrated IR Bullet Camera Configuration Follow the steps below to adjust the zoom and focus. Remove the lens cap before making adjustments, then replace it when you finish. Refer to the figure below. Figure 4.1 Lens adjustment...
WZ16 Integrated IR Bullet Camera Configuration | en Adjusting the Focus Loosen the focus lock screw by turning it counterclockwise. Adjust the focus by moving the focus lever to near side or far side. Turn the focus lock screw clockwise to tighten the focus lever after adjustment.
| Troubleshooting WZ16 Integrated IR Bullet Camera Troubleshooting Troubleshooting Tips Before sending the camera out for repair, check the items below. If the problem persists after checking these items, contact your service center. - If no image appears, verify that: –...
WZ16 Integrated IR Bullet Camera Technical Specifications | en Technical Specifications Electrical Power 12 VDC (±10%) Max 700 mA 24 VAC (±10%) Max 7 W Peak current: 2000 A (8/20 μs) Surge Suppression Power Input Peak power: 5500 W (2 ms)
Page 22
| Technical Specifications WZ16 Integrated IR Bullet Camera Mechanical Dimensions (H x W x L) – Camera 115 mm x 60 mm x 60 mm (4.53 in. x 2.36 in. x 2.36 in.) – Bracket 60 mm x 60 mm x 97 mm (2.36 in.
Page 23
WZ16 Integrated IR Bullet Camera Technical Specifications | en Dimensions Below are several dimensional drawings of the camera. Unit of measure is mm. Figure 6.1 Front view Number Description Photocell 18 LED Figure 6.2 Bottom view Bosch Security Systems, Inc.
Page 24
| Technical Specifications WZ16 Integrated IR Bullet Camera Figure 6.3 Side view Figure 6.4 Mounting bracket | 1.0 | 2011.02 Installation Manual Bosch Security Systems, Inc.
Need help?
Do you have a question about the WZ16 and is the answer not in the manual?
Questions and answers