Connection In Applications; Important Notices - Bosch AUTODOME IP starlight 5000i Installation Manual

AUTODOME IP starlight 5000i (pendant)
1.6

Connection in Applications

24 VAC power source: This unit is intended to operate with a limited power source. The unit
is intended to operate at 24 VAC (if PoE+ is not available). User supplied wiring must be in
compliance with electrical codes (Class 2 power levels).
PoE: Use only approved PoE+ devices. Power-over-Ethernet can be connected at the same
time as a 24 VAC power supply.
If auxiliary power (24 VAC) and PoE+ are applied simultaneously, the camera selects auxiliary
input and shuts off PoE+.
24 VAC power source: This unit is intended to operate at 24 VAC (if PoE is not available).
User-supplied wiring must be in compliance with electrical codes (Class 2 power levels).
PoE: Use only approved PoE (802.3at or 802.3bt) devices. Power-over-Ethernet can be
connected at the same time as a 24 VAC power supply. If auxiliary power (24 VAC) and PoE
are applied simultaneously, the camera selects PoE and stops auxiliary input.
For pendant models used in outdoor applications that require heaters, 24 VAC power is
required to power both the camera and its internal heaters.
For in-ceiling or indoor pendant applications that don't require heater power, standard PoE+
(802.3at) midspans or switches can be used to power the camera.
1.7

Important notices

NDP-5512-Z30│NDP-5512-Z30-P│NDP-5512-Z30C│NDP-5512-Z30C-P:
UL disclaimer
Underwriter Laboratories Inc. ("UL") has not tested the performance or reliability of the
security or signaling aspects of this product. UL has only tested fire, shock and/or casualty
hazards as outlined in Standard(s) for Safety for Information Technology Equipment, IEC
62368-1.
UL MAKES NO REPRESENTATIONS, WARRANTIES, OR CERTIFICATIONS WHATSOEVER
REGARDING THE PERFORMANCE OR RELIABILITY OF ANY SECURITY OR SIGNALING-RELATED
FUNCTIONS OF THIS PRODUCT.
FCC statement (USA)
Notice!
i
This is a class A product. In a domestic environment this product may cause radio
interference, in which case the user may be required to take adequate measures.
FCC & ICES Information
(U.S.A. and Canadian Models Only)
This device complies with part 15 of the FCC Rules. Operation is subject to the following
conditions:
–
–
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada. These
limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and
radiates radio frequency energy and, if not installed and used in accordance with the
Bosch Security Systems
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause
undesired operation.
Installation Manual
Safety | en
2023-02 | 1.4 | F.01U.413.551
7