Important Notices - Bosch MIC IP fusion 9000i Installation Manual

MIC IP fusion 9000i
–
–
Notice!
i
To maintain the Type 6P rating when the camera is mounted to a MIC-DCA, installers must
make sure that the user-supplied cable glands or conduit connections have Type 6P ratings.
Warning!
Do not manually back drive the camera
The motor/gear head combinations used in the MIC cameras were designed to provide
smooth pan/tilt movement of the camera during powered operation. The gear heads were not
specifically designed to be manually "back-driven" under any circumstance.
!
Although it might be possible to do so on unpowered units, there is no guarantee that "back-
driving" will be possible on every unit. Some units may even enter a "locked-up" mechanical
state.
If the camera becomes "locked-up," simply apply power to the camera. The pan/tilt functions
of the camera should now operate properly.
Warning!
Moving parts!
!
Moving parts may result in risk of injury, therefore, the device should be mounted so that it is
accessible only to the technician/installer.
Notice!
i
Risk of injury or damage
To prevent injury to your hands or damage to the wiper, do not touch the wiper with your
hands, especially when the wiper is moving.
–
–
1.5

Important Notices

Notice!
i
This device is intended for use in public areas only.
U.S. federal law strictly prohibits surreptitious recording of oral communications.
Bosch Security Systems
Make sure that the installation conditions comply with the specified stresses of vibration
and shock as mentioned in the datasheet.
Use common-sense safety precautions, especially in situations where there could be risk
of injury if any part of the assembly becomes detached and falls. Bosch recommends
using the hinged DCA, which allows installers to "hang" the MIC camera temporarily on
the DCA to make electrical connections, before bolting the camera to the DCA.
Do not open the camera unit. Doing so will invalidate the warranty.
Do not point the camera at the sun. Bosch Security Systems will not be liable for any
damage to cameras that have been pointed directly at the sun.
Accessories - Do not place this unit on an unstable stand, tripod, bracket, or
mount. The unit may fall, causing serious injury and/or serious damage to
the unit. Use only with mounting solutions specified by the manufacturer.
When a cart is used, use caution and care when moving the cart/unit
combination to avoid injury from tip-over. Quick stops, excessive force, or
uneven surfaces may cause the cart/unit combination to overturn. Mount the
unit per the installation instructions.
Installation Manual
Safety | en
2022-09 | 1.6 | F.01U.334.820
7