Network; Network Access - Bosch NBC-265-W Installation And Operation Manual

110 en | Advanced Mode
6.8

Network

Network
>
>
>
>
>
6.8.1

Network Access

The settings on this page are used to integrate the device into a
network. Some changes only take effect after a reboot. In this
case Set changes to Set and Reboot.
1.
2.
The device is rebooted and the changed settings are activated.
If the IP address, subnet mask, or gateway address is changed,
then the device is only available under the new addresses after
the reboot.
Automatic IP assignment
If a DHCP server is employed in the network for the dynamic
assignment of IP addresses, activate acceptance of IP
addresses automatically assigned to the device.
Certain applications (Bosch Video Management System, Archive
Player, Configuration Manager) use the IP address for the
unique assignment of the device. If using these applications,
the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so
that, once an IP address is assigned, it is retained each time the
system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
AR18-10-B012 | v1.54 | 2011.08
Network Access
Advanced
WLAN
Multicast
FTP Posting
Make the desired changes.
Click Set and Reboot.
Installation and Operation Manual
IP Camera 200 Series
Bosch Security Systems