Bosch NBC-265-W Installation And Operation Manual page 84

120 en | Advanced Mode
If the operating status LED lights up red, the upload has failed
and must be repeated. To perform the upload, switch to a
special page:
1.
2.
Configuration
Save configuration data for the camera to a computer and load
saved configuration data from a computer to the device.
To save the camera settings:
1.
2.
To load configuration data from the computer to the device:
1.
2.
3.
Once the upload is complete, the new configuration is
activated. The time remaining is shown by the message going to
reset Reconnecting in ... seconds. When the upload is
completed successfully, the device reboots automatically.
SSL certificate
To work with an SSL connection, both sides of the connection
must have the appropriate certificates. Upload one or more
certificate files, one at a time, to the camera.
1.
2.
Once all files have been successfully uploaded, the device must
be rebooted. In the address field of the browser, enter /reset
after the camera's IP address, for example:
192.168.0.10/reset
The new SSL certificate is valid.
AR18-10-B012 | v1.54 | 2011.08
In the address bar of your browser, enter /main.htm after
the device IP address, for example:
192.168.0.10/main.htm
Repeat the upload.
Click Download; a dialog box appears.
Follow the instructions to save the current settings.
Enter the full path of the file to upload or click Browse to
select the desired file.
Make certain that the file to be loaded comes from the
same device type as the device to be reconfigured.
Click Upload to begin transmission to the device. The
progress bar allows monitoring of the transfer.
Enter the full path of the file to upload or click Browse to
locate the file.
Click Upload to start the file transfer.
Installation and Operation Manual
IP Camera 200 Series
Bosch Security Systems