Wlan - Bosch NBC-265-W Installation And Operation Manual

IP Camera 200 Series
RTSP port
If necessary, select a different port for the exchange of the
RTSP data from the list. The standard RTSP port is 554. Select
Off to deactivate the RTSP function.
UPnP
Select On to activate UPnP communication. Select Off to
deactivate it.
When UPnP is activated the camera reacts to requests from the
network and is registered automatically as a new network
device on the inquiring computers.
Note:
To use the UPnP function on a computer with Windows XP or
Windows Vista, the Universal Plug and Play Device Host and the
SSDP Discovery services must be activated
This function should not be used in large installations due to
the large number of registration notifications.
TCP metadata input
The device can receive data from an external TCP sender, for
example an ATM or POS device, and store it as metadata.
Select the port for TCP communication. Select Off to
deactivate the function. Enter a valid Sender IP address.
6.8.3

WLAN

To use a wireless LAN connection proceed as follows:
1.
2.
3.
4.
Note:
To enhance network security, only WPA-PSK (TKIP) and WPA2-
PSK (AES) encryption is supported.
Bosch Security Systems
To activate the wireless LAN connection select Auto from
the drop down box.
Select your region in the Region code drop down box.
If you know the service set identifier enter it in the SSID
box. If you do not know, click Scan to see a list of available
services and then click a service.
Enter the encryption key to get access to the network in
the PSK box. Reboot and remove Ethernet cable immediately.
Installation and Operation Manual
Advanced Mode | en 115
AR18-10-B012 | v1.54 | 2011.08