Display Stamping - Bosch NBC-265-W Installation And Operation Manual

IP Camera 200 Series
5.
6.
7.
8.
9.
Note:
If a table is not created, there is no automatic switching. When
editing the table, note that values occur in linked pairs (DST
start and end dates).
Time server IP address
The camera can receive the time signal from a time server using
various time server protocols and then use it to set the internal
clock. The device polls the time signal automatically once every
minute. Enter the IP address of a time server.
Time server type
Select the protocol that is supported by the selected time
server. It is recommended to select the SNTP server protocol.
This protocol provides high accuracy and is required for special
applications and future function extensions. Select Time server
if the server uses the RFC 868 protocol.
6.2.4

Display Stamping

Various overlays or stamps in the video image provide
important supplementary information. These overlays can be
enabled individually and arranged on the image in a clear
manner.
Camera name stamping
This field sets the position of the camera name overlay. It can
be displayed at the Top, at the Bottom, or at a position of
choice using the Custom option, or it can be set to Off for no
overlay information.
Bosch Security Systems
Click one of the entries in the table to make changes. The
entry is highlighted.
Click Delete to remove the entry from the table.
Choose other values from the list boxes under the table, to
change the selected entry. Changes are immediate.
If there are empty lines at the bottom of the table, for
example after deletions, add new data by marking the row
and selecting values from the list boxes.
When finished, click OK to save and activate the table.
Installation and Operation Manual
Advanced Mode | en
AR18-10-B012 | v1.54 | 2011.08
73