Table of Contents
Advertisement
16
en | Quick install
3
Quick install
To get the unit quickly operational, make the connections described below and then enter the
relevant data in the Quick install menu. The Quick install menu appears the first time the unit
is started.
3.1
Connections
Figure 3.1 Back panel connections for the Advanced model
Figure 3.2 Back panel connections for the Basic model
3.1.1
Primary connections
1.
2.
3.
3.1.2
Optional connections
1.
2.
3.
4.
5.
6.
7.
8.
3.1.3
Powering up
Switch on all connected equipment.
–
F.01U.168.054 | v2.0 | 2012.05
Connect the cameras to the VIDEO IN BNC connectors (automatically terminated).
Connect monitor A to the VGA MON A output (supporting 800x600, 1024x768, or
1280x1024).
Connect USB mouse to a USB port.
Connect monitor B to the MON B BNC connector.
Connect up to 4 audio signals to the AUDIO IN RCA (CINCH) inputs.
Connect the AUDIO OUT RCA (CINCH) output to the monitor or an audio amplifier.
Connect up to 4 ALARM IN inputs (via the supplied terminal blocks).
Connect up to 4 ALARM OUT outputs (via the supplied terminal blocks).
Connect a pan/tilt/zoom control unit to the RS-485 port (via the supplied screw terminal
block).
Connect to your network via the RJ-45 Ethernet port.
Connect a "Bosch RS232 to Bi-phase converter" to the RS-232 port if required.
Connect the power cord to the unit.
Installation and Operation manual
Video Recorder 430/451 Series
Bosch Security Systems
Advertisement
Table of Contents
