ATEN KN9108 User Manual page 45

(Continued from previous page.)
The Configuration page settings are explained in the following table:
Setting
OSD Hotkey Selects which Hotkey controls the OSD function: [Scroll Lock]
[Scroll Lock] or [Ctrl] [Ctrl]. Since the Ctrl key combination may
conflict with programs running on the computers, the default is the
Scroll Lock combination (see Hotkey Operation, page 67).
ID Display Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or the
Port Number plus the Port Name (PORT NUMBER + PORT
NAME). The default is PORT NUMBER + PORT NAME.
ID Duration Determines how long a Port ID displays on the monitor after a port
change has taken place. You can choose an amount from 0–255
seconds, or enable Always On for the Port ID to be always
displayed. The default is 5 Seconds. 0 is Always Off.
Scan Select Selects which computers will be accessed under Auto Scan Mode
(see Auto Scanning, page 67). Choices are: ALL – All the Ports
which have been set Accessible (see Port Access, page 38);
POWERED ON – Only those Ports which have been set
Accessible and are Powered On; QUICK VIEW – Only those Ports
which have been set Accessible and have been selected as Quick
View Ports (see Quick View Ports, page 27); QUICK VIEW +
POWERED ON – Only those Ports which have been set
Accessible and have been selected as Quick View Ports and are
Powered On. The default is ALL.
Scan Duration Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see Auto Scanning,
page 67). Key in a value from 0–255 seconds. The default is 10
seconds; a setting of 0 disables the Scan function.
Screen Blanker If there is no input from the console for the amount of time set with
this function, the screen is blanked. Key in a value from 1–30
minutes. A setting of 0 disables this function. The default is 0
(disabled).
Logout Timeout If there is no Operator input for the amount of time set with this
function, the Operator is automatically logged out. A login is
necessary before the KN9108 / KN9116 can be accessed again.
Enter a value from 0–180 minutes. The default is 30 minutes. 0
disables the function.
Beeper When set to ON, the beeper sounds whenever the port is switched,
when activating the Auto Scan function (see Auto Scanning,
page 67), or when an invalid entry is made on an OSD menu. The
default is ON.
Change Allows a user to change the account password. After clicking the
Password Change Password button, a dialog box appears. Enter the old
password. Then, enter a new password and confirm it by entering it
again. Press OK to save changes, or press Cancel to discard
changes.
Chapter 4. Administration
Function
33