Specifications - GBC DocuBind TL200 Instruction Manual

DOCUBINDTL200
Binding
Place the large loops of the wire element into the Wire
1
Holder as shown in figure 3. Be sure it is firmly secured
with the small loops facing towards you.
Place your punched pages face up onto the small loops of
2
the wire element (see figure 4 inset). Then place your front
and back covers face-to-face against each other. Place the
covers onto the wire element with the front cover first and
the inside of the back cover facing upward. This step
ensures that after crimping the seam of the wire element
will be hidden between the back cover and last page
(figure 4).
Empty chip drawer
Empty Chip Drawer (F) after repeated use. Pull drawer
1
gently toward you to open. When putting back in, the
drawer will snap into place (see figure 1).

Specifications

Dimensions
Weight
Punch Capacity
Bind Capacity
Maximum Sheet Width
Dis-engagable Pins
Guarantee
Operation of this machine is guaranteed for one year from
date of purchase, subject to normal use. Within the guarantee
period, GBC will at its own discretion either repair or replace
the defective machine free of charge. Defects due to misuse
or use for inappropriate purposes are not covered under the
guarantee. Proof of date of purchase will be required. Repairs
Register this product online at www.GBCOffice.com
GBC DocuBind TL200
18" (W) x 8 1/2" (H) x 16" (D)
457mm x 216mm x 406mm
27 Ibs. (12.5 kg)
20 sheets of 20 Ib. paper
20 sheets of 80gm 2 paper
125 sheets or 9/16" (14mm)
11.7" (297mm A4)
1 (A5 paper) within wire storage bin
Hold the wire element firmly at each end of the book and
3
remove it from the Wire Holder by sliding it to the left or
lifting it off. While firmly holding the wire element and
document at one end place the book with the open end of
the wire face down into the Wire Crimper. You can release
the book so it rests against the support rack or continue to
hold it with one hand (figure 5).
To crimp the wire together pull the handle down toward
4
you completely until it goes no further. Remove the book
and flip the front cover around to the front. Your
presentation is now complete. If the wire is not closed
properly (see figure 6) adjust Dial (E) accordingly.
Service
• Contact an authorized GBC service representative for any
required repairs.
or alterations made by persons not authorised by GBC will
invalidate the guarantee. It is our aim to ensure that our
products perform to the specifications stated. This guarantee
does not affect the legal rights which consumers have under
applicable national legislation governing the sale of goods.