Section 7.0 Replace Lid Moulding; Section 7.1 Replacement Of Heater Assembly; Section 7.2 Replacement Of Fixing Blocks - Rexel T300 Service And Parts Manual

SECTION 7.0 (From serial no A545818)
Replace Lid Moulding
5. Remove lid from top cover, by bowing inwards to release hinge pins.
6. Replace lid.
7. Check that pivot pins are correctly aligned in top cover.
8. Check lid opens and closes correctly.
SECTION 7.1
a. Replacement of Heater Assembly (including Thermistor)
1. Carry out procedures 1 to 4 in section 6.0.
2. The heater assembly is secured to 2 off heater fixing blocks by four fixing screws.
3. Remove the four fixing screws.
4. Unclip heater wire/thermistor and mains connectors from PCB assembly.
5. Lift and remove heater assembly complete.
6. To reassemble machine, reverse sequence of operation 1 to 5.
SECTION 7.2
Replacement of Fixing Blocks
7. Carry out procedures 1 to 4 section 7.1
8. Turn base moulding upside down.
9. Remove service decal and rating plate.
10. Unscrew four fixing screws
11. Blocks can now be replaced
12. Reassemble machine in reverse sequence of operations 1 to 4.
T300.doc
Issue No 1
ILLUSTRATED PARTS MANUALS
T300 THERMAL BINDER
220-240V
16