Connector 1 - Tv Loop Out; Vcr Aux Scart - Strong SRT 5000 Instruction Manual

Connector 1 - TV Loop Out

For Aerial Signal Pass through
to your TV or VCR/DVD
This is the signal coming from your antenna and
passing through the SRT 5000
This can be used for a variety of purposes as per
items A and B as follows.
A. With a separately purchased RF Lead, you can
connect from this connector to your TV antenna IN.
This enables you to switch back to normal analogue
viewing. I.e. you would switch back to normal TV ana-
logue mode by pressing the TV Mode button on your
TV Remote Control.
B. You can choose to connect RF from this connector
to your VCR (separately purchased Lead) which will
enable you to watch a normal Digital Broadcast
Channel through the SRT 5000 and at the same time
you can record a different broadcast channel into the
VCR.
Therefore, as you are watching your digital channel
through the SRT 5000 you would select a channel via
your VCR Remote Control and press Record Button
on your VCR.
E.g. you may be watching the Digital transmission of
CH 7 through the SRT 5000 as normal and recording
CH 9 RF analogue through your attached VCR.
VCR AUX Scart (CVBS
Composite) for Video Out
On the rear panel there is a Second Scart called VCR
Scart (Connector 5)
(Requires separately purchased Scart Lead for con-
nection to VCR or DVD)
This will enable you to RECORD to your attached
video devices
Push Record on your VCR / DVD Remote Control.
22