Installation - Alpine CDE-9880R Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Less than 35°
1
Bracket
Mounting Sleeve
(Included)
Pressure Plates*
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit (see
"Removal" on page 28). Slide the mounting sleeve
into the dashboard and fix it with the metal shackles.
28
-EN
Detachable
Front Panel
Rubber Cap
(Included)
Hex Bolt
(Included)
Dashboard
This unit
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDE-9880R/
CDE-9882Ri and put the Rubber Cap on the hex bolt.
If your vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all other leads of the
CDE-9880R/CDE-9882Ri according to details
described in the CONNECTIONS section.
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the CDE-9880R/CDE-9882Ri into the
dashboard. When the unit is in place, make sure the
locking pins are fully seated in the down position.
This can be done by pressing firmly in on the unit
while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard. Install the detachable front panel.
Removal
1. Remove the detachable front panel.
2. Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3. Pull the unit out, keeping it unlocked as you do so.
Screw
Bolt Stud
∗
This unit
Lock Pin