Rds; Setting Rds Reception Mode And Receiving Rds Stations; Recalling Preset Rds Stations; Receiving Rds Regional (Local) Stations - Alpine CDE-9880R Owner's Manual

RDS

Rotary encoder
BAND/TA /ENT
VIEW F/SETUP
/ESC
Setting RDS Reception Mode and
Receiving RDS Stations
The RDS (Radio Data System) is a radio information system using the
57 kHz subcarrier of regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic information, station
names, and to automatically re-tune to a stronger transmitter that is
broadcasting the same programme.
1
Press F/SETUP so that the
2
Press 1 AF to activate the RDS mode.
3
Press or to tune in the desired RDS
station.
4
Press 1 AF again to deactivate the RDS mode.
5
Press F/SETUP to activate the normal mode.
The indicator goes out.
• When the "Setting PTY31 (Emergency Broadcast) reception" (refer
to page 10) is set to on, if the unit receives the PTY31 (Emergency
Broadcast) signal, the unit will show "ALARM" in the display
automatically.
• Operate the unit while the
is performed for 10 seconds, the
The RDS digital data includes the following:
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
EON Enhanced Other Networks
NEWS 2 3 PTY
1 AF
indicator lights up.
indicator lights up. If no operation
indicator goes out.

Recalling Preset RDS Stations

1
Press F/SETUP so that the
2
Press 1 AF to activate the RDS mode.
3
Press F/SETUP to activate the normal mode.
The indicator goes out.
4
Make sure that the
then press the preset button in which your desired
RDS station is preset.
If the preset station's signal is weak, the unit automatically
searches and tunes to a stronger station in the AF
(Alternative Frequencies) list.
5
If the preset station and the stations in the AF list
cannot be received:
When the PI SEEK setting is on (refer to "PI SEEK Setting"
on page 10), the unit searches again for a station in the PI
(Programme Identification) list.
If there are still no stations receivable in the area, the unit
displays the frequency of the preset station and the preset
number disappears.
If the signal level of the Regional (Local) station being tuned
becomes too weak to receive, press the same preset button
to tune in a Regional station in other district.
• For presetting the RDS stations, refer to the Radio Operation section.
The RDS stations can be preset in the F1, F2 and F3 bands only.
• Operate the unit while the
is performed for 10 seconds, the
Receiving RDS Regional (Local)
Stations
1
Press and hold F/SETUP for at least 2 seconds to
activate the SETUP mode.
2
Turn the Rotary encoder to select the RDS
REGIONAL mode, and then press
3
Turn the Rotary encoder to select ON or OFF.
In the OFF mode, the unit automatically keeps receiving the
related local RDS station.
4
Press and hold F/SETUP for at least 2 seconds to
return to normal mode.
• Press /ESC to return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
indicator lights up.
indicator light goes out,
indicator lights up. If no operation
indicator goes out.
/ENT.
9
-EN