Table of Contents
Advertisement
3
Hardware Installation
Before installing your camera,
make sure the built-in PIR (Passive
Infrared Sensor) can be directed
toward the area of interest, where
possible intrusion may occur. (The
sensitivity of PIR sensor depends
on the object size and temperature
differences between the object and
the background environment.)
Use the included T10 Torx screwdriver to loosen screws on the sides of dome cover to
remove it. You should then jot down the MAC address printed on the bottom of the camera.
Remove the black cover as shown below so that you can fine-tune the focus and zoom the
camera later when the cabling is done.
50
5m
50
Dome Cover
Dome Cover
Tilt Ajustment
Screw
EN - 5
Top View
5m
41
41
Bottom of the
Camera
Side View
Focus Ctrl
Zoom Ctrl
Advertisement
Table of Contents
