Table of Contents
Advertisement
8
Completion
1. Align the notches on the inner side of the black cover with the rivets on the sides of the
lens, and then fix the black cover.
2. If you choose to feed the cable through the ceiling/wall, arrange the cables neatly
through the cable hole A (not shown in the drawing). If you choose to feed the cable
from the side, remove plate B.
3. Attach the dome cover to the camera as the direction shown below. Tighten two screws
from the sides of the dome cover.
4. Finally, make sure all parts of the camera are securely installed.
A
1
Black Cover
Black Cover
2
Dome Cover
Dome Cover
1. When mounting the camera, you can use the key hole slot at the bottom. The key hole
slot helps facilitate installation and a safe mounting. First fasten a pioneer screw to the
wall/ceiling. Mount the camera to the screw.
2. Use a pencil to mark the locations of the 3 permanent mounting holes.
3. When cabling and the initial adjustment is done, mount the camera by fastening screws
to the 3 mounting holes.
Key Hole Slot
Mounting Holes
Be aware of the
cable route!
EN - 11
3
B
Pioneer Screw
Advertisement
Table of Contents
