Assembly - Healthrider Pro H250i Treadmill User Manual

2 1/2" Bolt (37)–2

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key
(84)–2
Extension Leg Bolt (96)–4
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic
parts, do not use power tools for assembly.
3/4" Tek Screw (72)–2
3/8" Star
Washer (83)–4
2 3/4" Upright Bolt (85)–2
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (26) so the treadmill is more sta-
ble. Do not fully fold the Frame until the
treadmill is completely assembled.
Identify the Right Upright (76), which has a
sticker attached to it. Hold the Right Upright in
the position shown. Next, locate the long wire in
the lower end of the Right Upright (see the inset
drawing). Securely tie the long wire to the Upright
Wire (75). Then, pull the opposite end of the long
wire until the Wire Harness is extending from the
upper end of the Right Upright. Make sure that
the Upright Wire is on the indicated side of
the Right Upright.
Finger tighten a 2 3/4" Upright Bolt (85) and a 1"
Upright Bolt (84) with two 3/8" Star Washers (83)
into the bottom of the Right Upright (76). Do not
tighten the Upright Bolts yet.
3 1/2" Bolt (45)–4
3/4" Screw (23)–10
Endcap Screw
Pulse Bar Star
(108)–2
Washer (65)–4
Wheel Nut (32)–2
and your own Phillips screwdriver
Wheel Nut (13)–2
1" Tek Screw (77)–6
Pulse Bar
Screw (64)–4
1" Upright Bolt (84)–2
1
76
26
6
Handrail Bolt (64)–4
.
Extension Leg Bolt (96)–4
Cover Screw (52)–4
Console Screw (67)–4
1 1/4" Bolt (63)–4
Wire
75
75
83
85
84