Healthrider Pro H250i Treadmill User Manual page 8

5. With the help of a second person, carefully raise
the Left Upright (70) and the Right Upright (not
shown) to a vertical position.
Attach the Latch Housing (71) to the Left Upright
(70) with two 3/4" Screws (23); start both
Screws and then tighten them. Note: Make
sure that the large hole in the Latch Housing
is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (71). Then, tighten the knob onto the
pin.
6. Insert the tab on one of the Handrail Brackets
(79) into the indicated slot in the Left Upright
(70). Attach the Handrail Bracket with a 3/4" Tek
Screw (72).
Attach the other Handrail Bracket (not shown) to
the Right Upright (not shown) as described
above.
7. Identify the Left Handrail Cover (68), which has a
sticker attached to it. Slide the Left Handrail
Cover onto the upper end of one of the Handrails
(62). Slide one of the Handrail Caps (69) onto the
lower end of the Handrail. Make sure that the
small hole in the Handrail Cap is on the bot-
tom.
Slide the Handrail (62) onto the post on the Left
Upright (70) and onto the left Handrail Bracket
(not shown). Finger tighten two 1 1/4" Bolts (63)
into the Handrail and the post; do not fully
tighten the Bolts yet.
Tighten a 3/4" Screw (23) into the small hole in
the Handrail Cap (69) and into the Handrail
Bracket (not shown).
Slide the Right Handrail Cover (74) onto the
other Handrail (62). Attach the Handrail to the
Right Upright (76) as described above.
Firmly tighten the four 1 1/4" Bolts (63).
5
23
71
Knob
23
Large
Hole
6
79
72
7
63
68
62
69
Small Hole
23
8
70
Spring
Collar
Pin
70
Slot
Post
63
70
74
62
76
23
69
Small
Hole