Healthrider Pro H250i Treadmill User Manual page 9

8. Orient the Pulse Bar (66) as shown. Attach the
Pulse Bar to the Left and Right Uprights (70, 76)
with four Pulse Bar Screws (64) and four Pulse
Bar Star Washers (65). Firmly tighten the
Pulse Bar Screws.
9. While a second person holds the console as-
sembly near the Pulse Bar (66), connect the
Ground Wire (107) on the Pulse Bar to the
ground wire on the console assembly.
Next, connect the indicated wire on the console
assembly to the Upright Wire (75). Make sure to
connect the connectors properly (see the
inset drawing). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and then try again. IF
THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Insert the connectors downward into the Right
Upright (76).
10. Set the console assembly on the Left and Right
Uprights (70, 76). Be careful not to pinch any
wires.
Attach the console assembly to the Pulse Bar
(66) with six 3/4" Screws (23). Do not tighten
the Screws yet.
8
64
65
70
9
Ground
Wire
107
66
10
Console Assembly
66
23
76
9
66
64
76
Console
Assembly
75
Wire
75
76
23
23
70
65