Healthrider Pro H250i Treadmill User Manual page 19

THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps
track of the total number of hours that the treadmill has
been operated and the total number of miles or kilome-
ters that the walking belt has moved. The information
mode also allows you to select miles or kilometers as
the unit of measurement and to turn on and turn off the
demo mode.
To select the information mode, hold down the Stop
button while inserting the key into the console. When
the information mode is selected, the following informa-
tion will be shown in the display:
The left side of the display
will show the total number of
miles or kilometers that the
walking belt has moved and
the total number of hours
that the treadmill has been
used. An "E" for English miles or an "M" for metric kilo-
meters will appear in the right side of the display. Press
the Quick Speed increase button to change the unit of
measurement.
IMPORTANT: If a "d" appears in the right side of the
display, the console is in the "demo" mode. This mode
is intended to be used only when a treadmill is dis-
played in a store. When the console is in the demo
mode, the power cord can be plugged in, the key can
be removed from the console, and the indicators in the
display will automatically appear in a preset sequence,
although the buttons on the console will not operate. If a
"d" appears when the information mode is selected,
press the Quick Speed decrease button so the "d"
disappears.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor adds even more fea-
tures to the console. The chest pulse sensor offers
hands-free operation, and enables you to use the con-
sole's two heart rate programs. To purchase the op-
tional chest pulse sensor, please see the front
cover of this manual.
Km
Hours
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Remove the key from the console and unplug the
2. Connect the wire on the receiver (A) to the indicated
3. Make sure that no wires are pinched. Reattach
19
power cord.
Remove the 3/4" Screw (23) and the Access Door
(100) from the back of the Console Base (98).
wire extending from the Console Base (98). Hold
the receiver so the small cylinder is oriented as
shown and is facing the Console Base. Attach
the receiver to the plastic posts on the Access Door
(100) with the two included small screws.
the Access Door (100) with the 3/4" Screw (23).
Discard the other wires included with the receiver.
98
100
23
Wire
Small
Screws
Small
A
Cylinder