Healthrider H150t Treadmill User Manual page 8

2. Make sure that the power cord is unplugged.
With the help of a second person, tip the tread-
mill onto its right side.
Pull the Upright Wire (91) and the base ground
wire (A) through the indicated hole in the
Base (29).
Attach the base ground wire (A) to the Base (29)
with a #8 x 1/2" Silver Screw (6).
Make sure that the Grommet (90) is pressed into
the square hole in the Base (29).
See the inset drawing. Cut the plastic tie near
the Upright Wire (91). Be careful not to dam-
age the Upright Wire.
3. Attach the Left Wheel Cap (110) to the Base (29)
with two #8 x 3/4" Screws (14).
Next, attach four Base Pads (37) to the Base
(29) with eight #8 x 3/4" Tek Screws (13) (only
two Base Pads are shown). Do not overtighten
the Screws.
With the help of a second person, tip the tread-
mill so that the Base (29) is flat on the floor.
Attach the Right Wheel Cap (not shown) as
described above.
2
Hole
6
29
A
90
Tie
Cut
91
3
37
13
29
8
91
14
37
110
13