Healthrider H150t Treadmill User Manual page 13

12. With the help of a second person, hold the con-
sole assembly near the Handrails (79) (only one
Handrail is shown).
Connect the ground wire from the console
assembly to the Ground Wire (80) on the Pulse
Crossbar (81).
Connect the Upright Wire (91) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
13. Set the console assembly on the Handrails (79).
Make sure that no wires are pinched. Insert
the excess Upright Wire (91) behind the Console
Frame (101).
Attach the console assembly to the brackets
on the Handrails (79) with the four 5/16" x 5/8"
Screws (11) that you removed in step 9. Do not
tighten the Screws yet.
12
Ground
Wire
80
Console
Wire
91
13
79
11
13
Console
Assembly
Console
Wire
91
79
81
Wire
Tie
Console
Assembly
101
91
79
11