Misc Maintenance; Troubleshooting - GBC 930-115 Operator's Manual

Polaris II
1.
Remove the film from the laminator.
2.
Preheat the laminator to 240 deg. F.
3.
Rub the top and bottom heat rollers with a clean, lint
free cloth and mineral spirits.
4.
Use the "Inching" funcion to rotate the heat rollers to a
new area for cleaning. Continue this process until the
complete surface of both rollers are clean.
5.
Use a damp cloth to clean the teflon roller.

7.3 Misc maintenance

-
Clean and lubricate chains with standard chain lubricant
four times per year.
-
Lubricate the gear reducers once a year with standard
grease.
-
Inspect and replace the suction cups as needed.
-
Follow the recomended maintenance for the Becker air
pump, as provided in the Becker instruction sheet.
Page 7-2

7.4 Troubleshooting

As an operator, you can perform some basic
troubleshooting before contacting your local service
representative.
WARNING: Never remove the side panels in
attempt to troubleshoot the laminator. You may cause
damge to other components or injury to yourself.
WARNING HAZARD: Do not open the side panels.
You will be exposed to dangerous voltage which can
shock.
CAUTION: Only trained technicians should perform
service related work on the laminator.
Refer to Figure 7.3.1 Troubleshooting Guide on page
7-3.
© 2004 General Binding Corporation
Operations Manual