Computer Associates BABNWUP900NE6 - BRIGHTSTOR ARCSERVE BACKUP V9 Manual page 15

Backup agent for microsoft exchange server
Hide thumbs Also See for BABNWUP900NE6 - BRIGHTSTOR ARCSERVE BACKUP V9:
Table of Contents

Advertisement

3. Click Next to display the Account Configuration setup dialog.
4. Enter the information for the mailbox. At this time, you can also specify the
port number and number of blocks in each data transfer you want to use
when TCP/IP is selected as the remote backup/restore protocol. Each data
block is 64 KB. If you want to change the port number, see the section
"Configuring the Port Address for the Backup Agent" in the "Introduction"
chapter of this guide.
5. Click Finish. If you checked the Create a NEW account to use with the
Exchange Brick Level Backup box, the following dialog displays.
Click Yes to continue.
If your Backup Agent Service Account is not configured correctly, a message
appears to inform you. If this occurs, the setup program allows you to use
only the database backup. You cannot perform mailbox level backups with
MAPI.
If you have configured your account correctly, the entire Backup Agent is
configured.
6. Click OK to complete the configuration.
Using the Backup Agent on Exchange Version 5.5
Configuring the Backup Agent
2–5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BABNWUP900NE6 - BRIGHTSTOR ARCSERVE BACKUP V9 and is the answer not in the manual?

Table of Contents