No Remote Output; Battery Information; Low Battery; Low Battery Alerts - Viper 4108V Owner's Manual

No Remote Output

Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.

Battery Information

The Responder LE remote is powered by 2 batteries (PN CR-2016)
and the 1-way companion remote by 1 battery (PN CR-2032) that
can be purchased at most retailers. When the battery begins to weak-
en, the operating range will be reduced. The information and precau-
tions in this section can help maximize your battery's life and usage in
providing your Responder LE 2-way and 1-way remote controls with
many years of trouble free operation.

Low Battery

After a command is performed the Responder LE 2-way and 1-way
remote control check their battery level and, when the level requires
attention, will begin generating alerts. Once the alerts begin, the re-
mote controls will remain operational for several days but the battery/
batteries should be replaced at the earliest opportunity or failure to
control the system may occur.

Low Battery Alerts

After performing a command, several beeps play on the Responder LE
2-way remote control to indicate the battery/batteries need replacing.
© 2012 Directed. All rights reserved. 7