Table of Contents
Advertisement
MODEL
PTS/U 40/25
PTS/U 50/30
PTS/U 75/50
PTS/U 100/65
PTS/U 125/80
PTS/U 150/100
PTS/U 175/110
PTS/U 200/125
10.3)
ADDING REFLECTORS
1. Slide the reflectors on the tube support/hanger brackets and through the wire hangers.
2. The tube at the coupling joints must be covered. Slide the reflectors together and provide an overlap of two (2")
inches for the first reflector overlap after the control unit. All remaining reflector overlaps will be approximately
one (1") inch. This will allow for the natural expansion and contraction of the heater when in operation. Note: The
heaters can expand and contract up to 1-3/4" of an inch.
3. Secure the reflectors as shown in Detail "A" using #10 x 1/2" self-drilling sheet metal screws at each tube
support/hanger bracket.
Form #43343530
July 08
2 Ft. Turbulator Sections
4
5
5
3
7
4
0
1
–21–
Advertisement
Table of Contents
