Installation Preparation; During Installation, Follow These Steps - Fagor Refrigerator Instruction Manual

Installation Preparation

Measure refrigerator to confirm that it
will fit through your doorway
Dimensions (including Door Handles)
35.67" (906mm) x 28.94" (735mm) x 69.69" (1770mm)
Find a suitable place to install
Sufficient space is needed from the back of the refrigerator
to the wall for proper air ventilation.
Avoid direct sunlight.
Once the location selected for the installation
Note
is prepared, please follow the installation instructions.
IIf the temperature outside the refrigerator drops to
below 41 degrees Fahrenheit the excess cold can
can cause irregular freezing of food in the refrigerator
compartment.
(Width*Depth*Height)
More than 2 inches (5 cm)
If the refrigerator can not
pass through your door
during installation, follow
these steps.
(This guide refers to several models. The real features are
model dependent.)
Removing Freezer Door
Remove the front bottom cover if it is attached.
Pull out bending tube Guide and the left water tube.
1
(Dispenser Models Only)
Unscrew top hinge cover with a screw driver.
2
Turn top hinge fastener counterclockwise 3~4 times.
3
Disconnect the harness wires.
Lift up the front of hinge to remove. (After the hinge is
4
removed the door can fall down forward. Be careful !)
Be careful not to damage the water line when removing
5
the door.
11