Monitoring System Status And Performance - Cisco ASR 5x00 Home eNodeB Administration Manual

▀ Monitoring System Status and Performance

Monitoring System Status and Performance
This section contains commands used to monitor the status of tasks, managers, applications and other software
components in the system. Output descriptions for most of the commands are located in the Counters and Statistics
Reference.
Table 6. System Status and Performance Monitoring Commands
To do this:
View HeNB-GW Service Information
View HeNB-GW services running on chassis
View summary of HeNB-GW sessions running on
chassis
View detailed information of HeNB-GW sessions
View HeNB-GW session information specific to an
S1 peer
Monitor HeNB-GW Subscriber Session Information
Monitor HeNB-GW subscribers by call identifier
Monitor HeNB-GW subscribers by user name
identifier
Monitor HeNB-GW subscribers by IMSI value
Monitor HeNB-GW subscribers by IP address of UE
Monitoring HeNB and UE by Protocol Monitoring
Monitor HeNB through Protocol Monitoring
Monitor UE through Protocol Monitoring
View Subscriber Information
Display Session Resource Status
▄ Cisco ASR 5x00 Home eNodeB Gateway Administration Guide
50
Enter this command:
show henbgw session all
show henbgw session summary
show henbgw session full
show henbgw session s1-peer ipv4-addr
monitor subscriber callid call_id
monitor subscriber usernamesubscriber_name
monitor subscriber imsiimsi
monitor subscriber ipaddripv4_address
monitor protocol
Use following protocol options for HeNB monitoring:

S1-AP

SCTP

GTP-U
monitor protocol
Use following protocol options for HeNB monitoring:

S1-AP

SCTP

GTP-U
Monitoring the HeNB-GW Service