Table of Contents
Advertisement
Configuring an NT mode system
Notes
When determining the number of RMU-01 units to use, refer to the "Installation of Remote Control Unit RMU-01" (page 62) section and
take the coverage area of the RMU-01 into consideration.
When supplying power to the RMU-01 via PoE, refer to the diagrams in the "Power supply (PoE) for RMU-01" section.
When operating from the receiver only
One DWR-R01D unit
Transmitters
DWR-R01D
Figure 5
Note
Use a crossover cable to connect the DWR-R01D to the RMU-01.
Multiple DWR-R01D units (2 to 41)
Transmitters
DWR-R01D
DWR-R01D
Straight
cable
Straight cable
RMU-01 (1 to 9)
Figure 6
Note
Use straight cables for all connections.
RMU-01
Crossover cable
Hub
When operating from the receiver and a computer
One DWR-R01D unit
Transmitters
DWR-R01D
Straight cable
Hub
Straight cable
Straight cable
Figure 7
Note
Use straight cables for all connections.
Multiple DWR-R01D units (2 to 41)
Transmitters
DWR-R01D
DWR-R01D
Straight cable
Straight
cable
RMU-01 (1 to 9)
Figure 8
Note
Use straight cables for all connections.
RMU-01 (1 to 9)
PC
(1 to 6)
Hub
Straight cable
PC
(1 to 6)
Network System Configuration
59
Advertisement
Table of Contents
