Table of Contents
Advertisement
Configuring a DWX System
DWX System Configuration
This section describes the process of configuring a system and provides information about limitations, frequency
support and other aspects.
System Sections and Configuration Flow
System configuration
In general, configuring a DWX system will involve the three devices listed below.
1. Audio equipment such as transmitters and receivers (audio section)
2. UHF transmission equipment such as antennas and dividers (UHF section)
3. Network communication equipment such as Remote Control Unit RMU-01 and
network hubs (network section)
DWX Microphone Series
DWX Transmitter Series
RMU-01
Remote Control Unit
System configuration flow
Use the following information as a guideline to the steps that are generally required when configuring a DWX
system.
Step 1
Selecting audio equipment
Step 2
Selecting UHF equipment
Step 3
Checking RF settings (UHF)
Step 4
Selecting network equipment
Step 5
Check network settings
DWM-01/F31
Digital Wireless
Microphone
DWM-01/C31
Digital Wireless
Microphone
WiDIF-HP
Wireless
transmission
DWT-B01
Digital Wireless
Transmitter
DWT-P01
Digital Wireless
Transmitter
Wireless
communication
Hub
Select transmitter (TX) side and receiver (RX) side audio equipment.
Select UHF transmission equipment according to the application type and scale of the
system.
Select suitable channel plan, RF power, antenna gain, and attenuator settings for usage
environment.
Select network equipment according to Cross Remote function requirements and the scale of
the system.
Make settings for network and check Cross Remote function.
2. UHF Section
AN-01
UHF Antenna
AN-820
UHF Antenna
3. Network section
Computer
Wired communication
BNC cable
LAN cable
1. Audio section (RX)
DWR-R01D
Digital Wireless Receiver
Wired
transmission
WD-850
UHF Antenna
DWR-S01D
Divider
Digital Wireless Receiver
DWA-01D
Digital Wireless Adapter
Computer
Hub
DWX System Configuration
31
Advertisement
Table of Contents
